Instructions to fill the Solo Pipe

• Before refilling the Solopipe, adjust the flame to low.

• Hold the Solopipe so the hole is facing up, and thebutane tank should be vertically down inserted onto the hole.

• Push the butane tank inwards and confirm a good fit, and there is no butane leaking out when pressure is applied.

• Apply pressure for a total of 5 or 6 times in short 1/2 second burst.

• Solopipe should then be shaken to allow for the gas to evenly distribute throughout the pipe's tubing.

• The SoloPipe should be left for a period of 5-10 minutes to room temperature before igniting. This allows for time for the gas to expand and fizzle out the air bubbles that are possibly generated in the filling process.

• You can reset the flame height back to your desired position.